DESCRIPTION
A hard, elastic, semi-transparent varnish for use
on timber surfaces exposed to sun and rain. It is resistant
to dirt and moisture.
PROTECTION
Protection against weather and wood-destroying ultra-violet
light. 3 coats are recommended. Minimum dry film thickness
on an even smooth surface: 60 micron, better 100 micron.
Box frames, timber windows, cladding and end grains
must be treated B E F O R E INSTALLATION
with one coat of BIO Wood Primer and one coat of Bio
Wood Varnish - clear. It is also good practice to prime
back surfaces. Reapply once
the finish appears to become dull.
PREPARATION
Prepare surface in accordance with AS 2311 Painting
of Buildings. Do not apply coatings
to unseasoned or wet timber. Wood and other surfaces should be well
sanded, dry and cleaned of greasy, waxy and dirty contaminants
using BIO Thinner. Round off sharp
edges. Imperfect coats may require complete stripping
before applying BIO Products.
Hardwoods
and other timbers rich in natural oils, waxes, acids
and terpenes should be degreased using BIO Thinner,
because these substances may mix with the varnish and
prolong its drying time.
PRIMING
For fungi and insect treatment use BIO WOOD PROTECTING
BORAX. Before painting, wipe off the surplus of Borax
with a damp cloth, otherwise surface residue may inhibit
paint adhesion.
APPLICATION
Stir thoroughly before use with a broad flat stirrer.
Brush thinly and evenly working varnish well into the
grain. Maintain a wet edge when
painting. Thick coats wrinkle when dry. Avoid bubbles.
Lightly sand between coats if necessary with fine sandpaper.
Allow 12 to 24 hours to dry between coats. Low temperatures
and humid conditions prolong the drying time. Apply
second and subsequent coats only after previous coat
has thoroughly dried. Do not use below 10 C and or
above 80% humidity or in cold, damp conditions;
when
condensation, rain, dew or frost are likely to occur;
on hot days; on hot surfaces; or in direct sunlight.
Provide adequate ventilation during application and
drying. Reaches maximum durability after 8-14 days.
RE-COATING
Re-coating is recommended after approximately 2 or
3 years, depending on the exposure to the weather.
CLEANING
Clean with BIO Thinner
INGREDIENTS
Based on modified plant oil,
wood oil, rosin, titanium
dioxide, mica, silica, bentone, soya lecithin, UV-protector,
paraffin oil, lemon peel oil, pine
oil, lead free drying agents.
COVERAGE
1 Litre covers approx. 10-12 sqm.
PACKAGING
1 and 4 Litres
SPECIAL PRECAUTION
Keep away from open flames and out of reach
of children. Do not misuse. Please dispose of used rags
in a sealed metal container. Can spontaneously combust.
STORAGE
Keep tightly sealed in a cool and dry place. Surface
film may develop in opened cans.
PAINT
DISPOSAL
Do not pour
leftover varnish down the drain. Unwanted oil should be
brushed out on newspaper, allowed to dry and then
dispose of via domestic waste collection. Let empty
container dry out as well and dispose of via recycling
program.
The
preceding information is given as a general guide only.
Some variations may occur or be advisable for particular
conditions. Our responsibility for claims arising from
breach of warranty, negligence or otherwise is limited
to the purchase price of the material.
BIO Wood Varnishes - clear is an
environmentally
friendly product.
1/8/2007
|
